The high-frequency inverter first uses high-frequency DC/DC conversion technology to invert low-voltage direct current into high-frequency and low-voltage alternating current; then, after being boosted by a high-frequency transformer, it is rectified by a high-frequency rectifier filter circuit to usually above 300V High-voltage DC power; finally, 220V power frequency AC power is obtained through the power frequency inverter circuit for the load.
[pdf] This article presents the first kW-Class, 3-phase GaN-based inverter. Hard-switched at 100-kHz PWM, its heart is a 6-in-1 power module with 600-V GaN power HEMTs, achieving a new efficiency of 98.5%, a more than 2% improvement.
[pdf] Overvoltage This is caused by a high intermediate circuit DC voltage. This can arise from high inertia loads decelerating too quickly, the motor turns into a generator and increases the inverter’s DC voltage. There are other causes of DC overvoltage, however. POSSIBLE FIXES: 1. Turn the overvoltage controller is. .
This is detected by an imbalance of the currents supplying the motor implying a leakage current to earth is present. This is usually caused by poor insulation resistance to earth. POSSIBLE FIXES: 1. Check insulation resistance of the motor and cabling. 2.. .
We hope you found the information in this article useful if you have a fault not listed and you need technical assistance contact our engineering team. .
This occurs when the motor is taking too much current with reference to the value in Group 99, motor data. POSSIBLE FIXES: 1. Check that motor’s load is not excessive. 2. Check acceleration time – too fast an acceleration of a high inertia load will cause too.
[pdf] 
