The voltage output of a standard solar photovoltaic panel typically falls in the range of 18 to 36 volts. Monocrystalline panels commonly produce around 36 volts, while polycrystalline options usually output between 18 and 24 volts.
[pdf] Inverters can be classed according to their power output. The following information is not set in stone, but it gives you an idea of the classifications and general. .
Specifications provide the values of operating parameters for a given inverter. Common specifications are discussed below. Some or all of the specifications usually. .
Determine the power that a solar module array must provide to achieve maximum power from the SPR-3300x inverter specified in the datasheet in Figure 1. Solution Because POUT (efficiency)(PIN) PIN = POUT/efficiency Using peak efficiency, the input power to the inverter must be PIN=POUT/Peak Efficiency=3,300 W/0.953=3,463 W.
[pdf] It is usually between 17-28V for a 12V panel. When a device or battery is hooked up, the solar panel’s output voltage drops. This voltage under load is lower and typically 14-24V for a 12V panel. Solar panels create DC electricity, which gets turned into AC by an inverter.
[pdf] 
