First-generation flywheel energy-storage systems use a large steel flywheel rotating on mechanical bearings. Newer systems use carbon-fiber composite rotors that have a higher tensile strength than steel and can store much more energy for the same mass.OverviewFlywheel energy storage (FES) works by accelerating a rotor () to a very high speed and maintaining the energy in the system as . When energy is extracted from the system, the flywheel's r. .
A typical system consists of a flywheel supported by connected to a . The flywheel and sometimes motor–generator may be enclosed in a to reduce fricti. .
Compared with other ways to store electricity, FES systems have long lifetimes (lasting decades with little or no maintenance; full-cycle lifetimes quoted for flywheels range from in excess of 10 , up to 10 , cycles.
[pdf] Here I have explained about a couple of simple circuit configurations which will convert any low power inverter to a massive high power inverter circuit. You'll find a plenty of small and medium sized inverter.
[pdf] An inverter converts a 60 Volt DC voltage (battery) into an AC voltage (230V-50Hz). The standard output voltage is 230 Volt, 50Hz with a pure sine wave. This means that this inverter supplies the same type of voltage as the wall socket. This allows any electrical device to work on it.
[pdf] 
