Why do we put solar panels together?

We put solar panels together to increase the solar-generated power. Connecting more than one solar panel in series, in parallel or in a mixed-mode is an effective and easy way not only to build a cost-effective solar panel system but also helps us add more solar panels in the future to meet our increasing daily needs for electricity.

Can I wire two solar panels produced by different vendors?

When you intend to wire two panels produced by different vendors, the vendors are not the problem. The problem is in different electrical characteristics of the panels, together with different performance degradation. We put solar panels together to increase the solar-generated power.

Can you mix different solar panels?

Mixing solar panels of various voltage or wattage, or produced by different manufacturers, is a frequently asked question by most DIYers. Though mixing different solar panels is not recommended, it’s not forbidden and things would be ok as long as each panel’s electrical parameters (voltage, wattage, amps) are carefully considered.

How do I connect solar panels in parallel?

To connect solar panels in parallel, you require an additional component known as an MC4 combiner (or MC4 multi-branch connector), this name differs for other types of solar panel connectors. The image above illustrates a 4-in-1 MC4 combiner, but these components can be 2 in 1, 3 in 1, and so on.

Why do solar panels need to be connected in parallel?

Connecting solar panels in parallel is just the opposite of series connection and is used to increase the total output current of the array, and hence the total output power while keeping the same voltage. ‘The same voltage’ is the system voltage which for off-grid solar panels systems is usually as low as either 6V or 12V.

Should solar panels be wired in parallel?

If you, however, need to get higher current, you should connect your panels in parallel. Should you need both a higher voltage and a higher current, you have to apply both connection modes, which means that a part of your solar panels should be wired in series, while the remaining ones are to be wired in parallel.