How to set up a dual output inverter?

This inverter is equipped with dual-output. There are two outputs: AC output 1 and AC output 2. It’s set up through LCD program or monitoring software to turn on and off the second output. Refer to “LCD setting” section for the details. Insert AC output wires according to polarities indicated on terminal block and tighten terminal screws.

Can I use a breaker for a 6kW inverter?

Note1: Also, you can use 50A for 6KW for only 1 unit and install one breaker at its AC input in each inverter. Note2: Regarding three-phase system, you can use 4-pole breaker directly and the rating of the breaker should be compatible with the phase current limitation from the phase with maximum units

What is the setting range for a 6kW battery?

For 6KW model, setting range is from 10A to 100A. Increment of each click is 10A. If “User-Defined” is selected, battery charge voltage and low DC cut-off voltage can be set up in program 17, 18 and 19. If selected, programs of 11, 17, 18 and 19 will be automatically set up. No need for further setting.

What is the default setting for WECO battery?

Default setting: 54V Battery stop charging voltage when grid is available 15% (default) If “WECO battery” is selected in program 14, this parameter will refer to the SOC of battery and adjustable from 15 to 100%. Page 23 Single: This inverter is used Parallel: This inverter is operated in in single phase application. parallel system.

What is a hybrid PV inverter?

for maintenance. This hybrid PV inverter can provide power to connected loads by utilizing PV power, utility power and battery power. Depending on different power situations, this hybrid inverter is designed to generate continuous power from PV solar modules (solar panels), battery, and the utility.

How do I Turn on the inverter?

Output is powered from Battery or Solar. Output is powered from Battery or Solar. Once the unit has been properly installed and the batteries are connected well, simply press On/Off switch (located on the button of the case) to turn on the unit. The operation and display panel, shown in below chart, is on the front panel of the inverter.